Idiomas disponibles
Idiomas disponibles
Keep all nuts and screws well tightened in order to ensure
a safe operation.
Always keep warning and indication stickers clean and
legible.
If any components or safety devices are removed for
maintenance
works,
immediately.
A power tool with double insulation does not need to be
grounded. The maintenance of this type of appliances
requires extreme care and knowledge and should only be
performed by a qualified technician. The components
replacement of a double insulated appliance must be
carried out with the same parts as the original ones.
Use only VITO-approved accessories for this high-pressure
washer or technically identical parts. Not doing so may
result in personal injuries or damages to the appliance. In
case of doubt, lack of knowledge or resources, you should
contact an official dealer.
Your washer should only be serviced by the manufacturer's
internal service personnel, or other qualified personnel,
replacing any necessary parts with original parts sourced
directly from the manufacturer.
1. Attach the hose support (14) to the transport handle and
tighten the fixing screws;
2. Attach the accessory supports (10, 11) to the machine
and tighten the fixing screws.
1. Insert the power cable support (6) into the fixing guide;
2. Insert the set support (gun + lance) (1) in the fixing
guide;
3. Make sure that the supports are securely fastened.
they
must
be
repositioned
1. Insert one of the hose connecting accessories in the
machine's connecting thread (9). Tighten the fixing
thread;
2. Insert the other hose connecting accessory in the gun's
connecting thread (13). Tighten the fixing thread.
Check the hose condition regularly and replace it, if
damaged. Do not attempt to repair a leaky hose.
1. Insert the lance connector in the gun fitting;
2. Press and rotate it counterclockwise until the lance (15)
is properly fastened;
3. Pull the lance to ensure it is fastened.
1. Connect the hose to the water supply tap;
2. Open the water supply tap to remove any debris that may
exist in the hose. When water comes out clean, turn off
the tap;
3. On the other end of the hose, place the quick release
coupling;
4. Remove the cover in the water inlet filter;
5. Screw the water inlet filter (8);
6. Fit the hose connector in the water inlet filter.
The water supply should preferably be provided by a hose
connected to a tap of the water supply system.
It is recommended the use of a garden hose with
½"diameter and a minimum length of 5 m.
If you want to draw water from wells, tanks or other type of
water containers, you must install an additional filter (hose
suction filter) to prevent sand or other type of waste intake.
In any of these situations, make sure that the inlet water
pressure is less than 7 bar.
