Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Operation
Sit down on the driver's seat.
Start the engine as indicated.
Set the throttle to
.
Switch the cutter deck on and then lower it.
Release the parking brake by pushing right
through the brake pedal and then releasing it
again.
To drive off, press on the accelerator pedal.
Do not mow wet grass. Drive slowly at
maximum engine speed. When adjusting the
cutting height and travel speed, ensure that
the device is not overloaded. Depending on
the length, type, and dampness of the grass,
adjust the cutting height and driving speed in
order to be able to collect grass with a grass
catcher without any trouble.
In the event of blockages, reduce speed and
raise the cutting height.
In the case of automatic shutdown through
the safety locking system (e.g. reversing
switch the switch off, and then back on
again, to release the clutch lock.
OCR function (model-dependent)
which offers you user-controlled mowing, even when
reversing.
Only use the OCR function if absolutely
necessary.
Start the engine.
Turn the ignition key [3] anti-clockwise from
normal position to reverse-mowing position
and press switch [1] .
or
Press switch [1]
for 3 seconds.
The indicator lamp [2] lights up. You can now mow
both when moving forwards and when reversing.
To terminate the OCR function, turn the ignition
key clockwise to the normal position
or
Press the switch [1]
release it.
The indicator lamp goes out.
769-12352A
.
downwards and then
The OCR function is switched off automati-
cally once the key is turned to the normal
position or the motor is shut down (stop
position or shutdown of the motor through
the safety lock system).
The OCR function is switched off automati-
cally once the OCR switch is pressed, the
engine is shut down or the safety lock sys-
tem automatically switches the engine or the
cutting mechanism off.
Tips on lawn care
Mowing
A lawn is made up of various different types of
grass. If you mow more frequently, the grown of
turf. If you seldom cut the grass, you will enhance
the development of high-growing types of grass and
other weeds (e.g. clover, daisies ...).
The normal height of a lawn is approx. 4–5 cm. Only
1/3 of the total height should be mown; therefore
cut 7–8 cm long grass to normal height. Preferably
do not cut the lawn shorter than 4 cm, otherwise the
turf will be damaged in a dry period. If the grass has
grown particularly high (e.g. during a holiday period),
cut it back to its normal height in stages.
Mulching using the accessories (optional)
With mulching, the grass is cut into small pieces
(approx. 1 cm) during mowing and is left on the
ground. A lot of the nutrients in the cut grass are
Ask your specialist dealer for appropriate mulching
accessories.
Note
This device is designed to mow lawns. Do
not mow scrub, weeds, or overlong grass.
Pay attention to the following notes:
Do not mow any wet grass, and never more
than max. 2 cm.
Mow the entire length of grass.
Drive slowly and at maximum engine speed.
Clean the lawn mower deck regularly.
Switching the device off
Stop the device.
Switch the cutter deck off.
Set the throttle to the middle position.
Bring the cutter deck to the top position.
Switch the engine off after 20 seconds.
Switch the parking brake on.
Shut the fuel tap.
Remove the ignition key.
EN
19
Capítulos
Tabla de contenido
