Ordering Replacement Parts; Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL CE-AP 18 Li Manual De Instrucciones Original

equipment. The switch will latch in place and
does not need to be held.
•
To switch off, press the switch (Item 5) again.
6.2 LED light (Fig. 1)
The LED lamp (Item 6) can illuminate the work
area in poor lighting conditions. It lights up auto-
matically when the equipment is switched on, and
it continues to shine for a few seconds when the
equipment is switched off .
6.3 Infl ating (Fig. 6/7)
Use the enclosed adapters if necessary.
•
Plug the large adapter (Item 3) onto the blow
connector (Item 2) and turn it to the left until it
locks in place.
•
Pug the small adapter (Item 4) onto the alrea-
dy mounted large adapter if needed.
6.4 Defl ating (Fig. 8)
Use one or, if necessary, both of the enclosed
adapters as shown.
Note:
To avoid problems during infl ation or defl ation,
make sure when you insert the small adapter into
standard valves that the usually existing non-re-
turn valve (valve fl ap) is open. This can be opened
slightly by gently squeezing the valve together.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
Anl_CE-AP_18_Li_Solo_SPK13.indb 18 Anl_CE-AP_18_Li_Solo_SPK13.indb 18
GB
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.

7.3 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 18 -
29.07.2021 15:20:28 29.07.2021 15:20:28