Uline H-2769 Manual Del Usuario página 2

NOTE: Existing system display must be powered
on before installing additional display.
1. Make sure the address on the back of the additional
display matches the address on the back of the
system display. (See Figure 3)
NOTE: If needed, use a mini flathead
screwdriver to change the address.
Address
2. Plug the data cable into either of the two data ports
located on the back of the system display.
(See Figure 4) The other end of the data cable will
be used in step 5.
PAGE 2 OF 6
Figure 3
Figure 4
INSTALLATION
3. Plug the power extension cable into the either of the
two power receptacles located on the back of the
additional display. Plug the other end of the power
extension cable into the AC power supply.
(See Figure 5)
Power
Extension Cable
4. Choose the appropriate country outlet adapter and
slide it into the AC power supply. (See Figure 6)
Plug the AC power supply into the nearest outlet.
5. Plug the other end of the data cable into either
of the two data ports located on the back of the
additional display.
NOTE: The additional display should show the
same number as the system display.
6. Use (+) and (-) buttons on the wireless remote (H-1713
and H-2770) or push buttons (H-1119) to change
numbers on both displays simultaneously.
7. OPTIONAL: Plug the terminator into the remaining
open data port on the additional display to prevent
data echoes.
1-800-295-5510
uline.com
Power
Extension
Cable
AC Power
Supply
Figure 5
Figure 6
0416 IH-2769