Danby Designer DDMW007501G1 Manual Del Propietário página 10

INSTALLATION INSTRUCTIONS
INSTALLATION
This microwave can be installed under a counter or
cabinet. Ensure that the surface is strong enough to
support the weight of the microwave and any food
that may be put into it.
Installation will require a fl at-bladed screwdriver, a
drill and a 9 mm drill bit.
Accessories such as washers and bolts can be found
in the accessory bag.
1. Remove the 4 plugs from the top of the
microwave using a screwdriver.
2. Place 2 washers and 1 bolt in the 4 holes on top
of the microwave. Do not tighten the bolts.
3. Measure the cabinet or counter where the
microwave will be installed. Ensure you have
adequate space on all sides. Dimensions on the
image are in inches. The cabinet must have a
weight endurance of greater than 22 kg (48.5
lbs). Measure and mark the center line of the
cabinet to ensure the microwave is balanced.
4. Measure and mark the location of the 4 screw
holes in the cabinet as per the diagram.
Dimensions on the image are in inches. Drill
four 9 mm holes into the cabinet at the noted
locations.
5. Insert the bolts into the holes from below and
then slide the C washers over the bolts and
tighten the bolts with a screwdriver.
1
2
3
4
5
9