5. Route the T-connector end with the Green wire across the
vehicle between the bumper and body to the passsenger's
side taillight assembly, RepeaConnector ends with the Green
wires.
6. Locate an appropriate position on the vehicle frame to
attach the White wire that has the ring terminal attached to it.
Drill a 3/32" hole and attach the T-Connectors White wire with
the ring terminal to the vehicle using the #10 screw provided.
Caution: Do not drill into any exposed surfaces or
through the vehicle body.
7. Route 4-Flat to the center of the vehicle. Attach 4-Flat to
the trailer hitch underneath the bumper for storage.
Caution: Make sure to avoid areas that could cut,
pinch or burn the wires when routing the harness
across the vehicle.
8. Confirm correct operation with a test light or by using a
trailer.
9. Replace both taillight assemblies positioning the wires
in order not to cut or pinch the wire.
