Electric Connections; Technical Data - Gewiss Chorus GW 18 361 Guia De Inicio Rapido

Electric connections

ATTENTION: before making the electric connections,
make sure all the equipment and cables are not powered.
Connect the network power supply (230 Vac) and the device
power supply cables (14.4 Vdc) to the corresponding screw termi-
nals, respecting the indications on the power supply label.
ATTENTION: do not exceed the permitted voltage and
current levels! Do not obstruct the ventilation openings!
Install a C curve, 16 A automatic, magneto-thermic bipo-
lar switch upstream in an easily accessible position.
In service

Signalling
The presence of SELV voltage at the output is signalled by the red
LED switched on near the terminals.
Device cleaning

Use a dry cloth to clean the audio/video power supply if necessary.
Pack Contents

1 Audio/video power supply
1 Instruction sheet

Technical data


Power supply
Powered outputs
Maximum delivered power
Maximum dissipated power
Display elements
Protections
Usage environment
Operating temperature
Storage temperature
Relative humidity
Electric connections
Weight
Degree of protection
Width (DIN modules) Reference standards
230 Vac ±10%, 50/60 Hz
GW 18 361: 1 x 14.4 Vdc rated, SELV
GW 18 362: 2 x 14.4 Vdc rated, SELV
GW 18 361: 18 VA
GW 18 362: 2 x 18 VA
GW 18 361: 3.9 W
GW 18 362: 6.9 W
Red LED for signalling output voltage (one
per output)
Short circuit protected at the output
Indoor, protected from the rain and water
infiltrations
0 ÷ +45 °C
-15 ÷ +70 °C
Max. 93% (non condensative)
Screw terminals, max. cable section:
2.5mm 2
0.12 kg
IP20
4 Safety: 2006/95/EC, EN 60065
Electromagnetic compatibility:
2004/108/EC, EN 61000-6-1, EN 61000-6-3