Battery Safety; Changing The Unit Of Measure - Stanley TLM50 Manual

Battery Safety

GB
WARNING:
Batteries can explode, or leak, and
can cause injury or fire. To reduce
this risk:
• Carefully follow all instructions and warnings on
the battery label and package.
• Always insert batteries correctly with regard to
polarity (+ and –), as marked on the battery and
the equipment.
• Do not short battery terminals.
• Do not charge disposable batteries.
• Do not mix old and new batteries. Replace all
batteries at the same time with new batteries of
the same brand and type.
• Remove dead batteries immediately and
dispose of per local codes.
• Do not dispose of batteries in fire.
Keep batteries out of reach of children.
Installing AAA Batteries
Locate the battery compartment latch on the
1.
back of the tool (Figure
Using your finger, pull the latch down to
2.
unlock and remove the battery door (Figure
).
C 1
3. Insert two AAA batteries, making sure to
position the - and + ends of each battery as
noted inside the battery compartment (Figure
).
C 2
Slide the pins at the bottom of the battery door
4.
into the notches in the battery compartment
(Figure
C 3
snaps into place.
When the tool is ON, the battery level appears in
the display window (Figure
4
).
B 2
), and push the door down until it
).
E 1
Using the TLM50/100
Point the laser at the top of the tool (Figure
1.
) toward the wall whose distance you
A 1
need to measure (Figure
2. Click (Figure
A 3
on the wall (Figure
distance from the bottom of the tool to the wall
(Figure ).
D 2
At the bottom of the display window (Figure
3.
), view the current measurement (Figure
A 2
), which will keep changing as you move
E 3
the tool (in Continuous Measure mode).
When the bottom of the tool is positioned at
4.
the correct distance from the wall, click
take the current measurement on the display
window (Figure
E 3

Changing the Unit of Measure

Once the current measurement is taken, you
can change the unit of measure from decimal ft
(6.21 ft) to fractional ft (6'02"9/16), fractional ft to
meters (1.894 m), meters to inches (74 9/16 in),
or inches to decimal ft.
To change the unit of measurement, press and
hold until you see the measurement change
(3 seconds).
NOTE: If you continue to hold
measurement changes, the tool will turn off.
Re-measuring
If you need to take a new measurement, click
• The previous measurement (Figure
appear above the new current measurement
(Figure ).
E 3
• When you are ready to take the new current
measurement, click
).
D 1
) to display a laser dot
) and measure the
D 1
).
after the
) will
E 2
.
to
.