Troubleshooting - TOUGHBUILT TB-H2-LL-100-L2 Instrucciones De Funcionamiento

Problem
Batteries are not inserted
Incorrect battery polarity
Low charge or dead batteries
No Laser Beam
Corroded battery terminals
Pendulum Switch
position
Defective Tool
Tool tilted beyond its ± 3.5°
self-leveling range
Fluctuating
Beam Depleted batteries
Temperature variation
Tool is turned on in the locked
Flashing Beam
position
Cannot Switch
Pendulum is in UNLOCK position.
the tool Off
Dirty reflector
Temperature variation
Erroneous
Results
Tool is bumped
Laser rebounds off reflective surface
Only one laser
H/V Selector buttom
beam is visible
When contacting ToughBuilt
claims, the information on your registration form will be required.

TROUBLESHOOTING

9.
Possible Cause
3
is in the LOCK
7
is activated
Industries, Inc. for customer service or warranty
®
Solution
Insert 3 x AA Alkaline batteries
Check battery polarity
Replace batteries with fresh
Alkaline batteries
Clean battery terminals
Slide the Pendulum Switch
the UNLOCK position
Have the tool repaired
Reposition the tool
Replace with fresh batteries
Allow time to stabilize
In locked and tilted mode, it is
normal for the laser beam to
fluctuate once every 5 seconds
Slide the Pendulum to the LOCK
position, then press the ON/OFF
button 6 .
Clean the reflector
Allow temperature to stabilize
Verify calibration
Allow laser to stabilize
Re-aim the laser
Push H/V Selector buttom
access cross laser
3
to
7
to
17