S T E P 5
Installation of ball bearings – for Sold Secure & ART approval ball bearings must be
hammered into the allen key holes. To install these use adhesive tape to hold the ball bearing
over the holes. Use a large hammer to hammer them into place then remove adhesive tape.
Note: Once ball bearings are hammered into allen key holes, removal of the AIRLOK unit is
not possible without damage to the wall or AIRLOK itself.
Remember: If you're unsure please call us, refer to our website www.hiplok.com or ask a
professional for help.
STEP 5 A
(OPTIONAL)
BALL BEARINGS
These should be held in with tape
then hammered into place for
a permenant fixing.
If you want to easily relocate your Airlok in the case
you change houses, Hexlox can be used instead of
the supplied ball bearings.
You can purchase the Hexlox Airlok Set from hexlox-
.com/Airlok
The set includes 2x #6mm Hexlox, 1x Coded Key +
Key code card.
The Hexlox are inserted into the top right and the
bottom left hex bolt that secure the Airlok to the wall.
The Hexlox blocks the bolt so an Allen Key can not be
inserted.
See instructions at hexlox.com/Airlok
Your Airlok is Sold Secure & ART approved ONLY
when the supplied ball bearings are used. In using
Hexlox this accreditation is void.
