Rules For Safe Operation - Surtek 111004 Manual De Usuario

CAT III: Distribution level, fixed installation, with
smaller transient over voltages than CAT. IV
Use the Meter only as specified in this operating manual,
otherwise the protection provided by the Meter may
be impaired. In this manual, a
conditions and actions that pose hazards to the user, or
may damage the Meter or the equipment under test.
A Note identifies the information that user should pay
attention on.
International electrical symbols used on the Meter and in
this Operating Manual are explained on page 5.

RULES FOR SAFE OPERATION

Warning
To avoid possible electric shock or personal injury, and to
avoid possible damage to the Meter or to the equipment
under test, adhere to the following rules:
• Before using the Meter inspect the case. Do not use the
Meter if it is damaged or the case (or part of the case) is
removed. Look for cracks or missing plastic. Pay attention to
the insulation around the connectors.
• Inspect the test leads for damaged insulation or exposed
metal. Check the test leads for continuity. Replace damaged
test leads with identical model number or electrical
specifications before using the Meter.
• Do not apply more than the rated voltage, as marked on
the Meter, between the terminals or between any terminal
and grounding.
• The rotary switch should be placed in the right position
and no any changeover of range shall be made during
measurement is conducted to prevent damage of the Meter.
• When the Meter working at an effective voltage over 60V in
DC or 42V rms in AC, special care should be taken for there
is danger of electric shock.
• Use the proper terminals, function, and range for your
measurements.
• Do not use or store the Meter in an environment of high
temperature,
strong magnetic field. The performance of the Meter may
deteriorate after dampened.
• When using the test leads, keep your fingers behind the
finger guards.
humidity, explosive,
E N G L I S H
Warning identifies
inflammable and
21