Assembly And Adjustments - DeWalt DW508S Manual De Instrucciones

WARNING: Always use eye protection. All users and
bystanders must wear eye protection that conforms to ANSI Z87.1.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V .......... volts
Hz ........ hertz
min ...... minutes
... direct current
........ Class I Construction n o ........ no load speed
............ ............ (grounded)
........ Class II Construction
............ (double insulated)
.../min . per minute
IPM ...... impacts per minute
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
Motor
Be sure your power supply agrees with the nameplate marking.
Voltage decrease of more than 10% will cause loss of power and
overheating. All D WALT tools are factory tested; if this tool does not
E
operate, check the power supply.
DESCRIPTION (FIG. 1)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. Variable speed switch
B. Lock-on button
C. Forward/reverse slider
D. Mode selector
E. Side handle
A .......... amperes
W......... watts
....... alternating current
....... alternating or direct current
........ earthing terminal
......... safety alert symbol
BPM .... beats per minute
RPM .... revolutions per minute
sfpm .... surface feet per minute
F. Depth adjustment rod
G. Keyed chuck
H. Sleeve
I. Chuck key
FIG. 1
D
I
H
F
G
E

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of injury, turn unit off and
disconnect tool from power source before installing and
removing accessories, before making any adjustments or
removing/installing attachments or accessories. An accidental
start-up can cause injury.
Side Handle (Fig. 1)
CAUTION: Always use side handle when provided and hold
hammerdrill with both hands.
A side handle (E) is supplied with this hammerdrill. It clamps to the
front of the gear case as shown in Figure 1 and can be rotated 360˚
to permit right or left hand use.
13
C
A
A
B
B