Use Environment; Product Manual; Maintenance - Airvom PLASMA W201 Guía De Usuario

Use environment

1. This product is for home or similar environments only, do not use outdoors.
2. Do not use this product in environments with high temperature, high humidity, excessive dust, corrosive, flammable and
combustible gases (eg. kitchen and bathroom).
3. Do not use the device near or in direct sunlight (eg. ovens, fans, heaters, or other heating devices).
4. Do not use the device during severe temperature fluctuations. Do not select the Aromatherapy or a similar mode when
turning on or prior to turn on the device.
5. While the machine is operating, place it on a stable and dry horizontal surface.
6. While the device is operating, check that the air intake and exhaust ports are 30cm (12 in) or more away from other
substances.
7. For details on the power parameters of this product, check the product specifications column below.
8. For safety reasons, children, elderly, and mentally weak people should use the product with supervision.

Product manual

1. Operation: After connecting the power, press "On/Off" gently to activate the air purifier, and press the "On/Off" button
again to turn off the device.
2. Purification speed: "Sleep (sleep mode), Low (standard mode), Fast (fast mode)" can be operated in 3 steps. When you
are suspicious of severe air pollution or contamination, it is recommended to select "Fast" for quick cleaning and select
"Sleep" mode when going to bed.
3. Timer: There are two options, "1 hour, 3 hours", please adjust the operating time.
4. Sterilization: When the power is turned on, the "Plasma" function is automatically activated. You can activate the "photoca-
talysis" function by touching the function key.
5. While the power is on, the plasma continues to run. If you want to stop the plasma function while power is running, you
can operate it with the plasma button on the remote controller.
6. Automatic air quality recognition: Built-in high-sensitivity odor detection sensor, detects air quality right after start-up,
switches to "Fast" mode when air quality is "bad" and when air quality is "good" or "normal" It is automatically adjusted
according to the system.
7. Filter replacement alarm: When the cumulative use time reaches 1,500 hours, three air quality indicators light up, and at
the same time, the alarm sound "DED" sounds. After replacing the filter, you can reset the device and cancel the alarm by
pressing the "Speed" and "Time" buttons simultaneously for 5 seconds (except for some models).
8. Remote control: The infrared remote control receiver is installed, and the effective distance is 4~5m. When using, point
the remote control towards the IR receiver located on the right side of the control panel.

Maintenance

Issues
Unit fails to turn-on
Purification ability is weak
Amount of purified
air is low
Abnormal noise
- If the above solutions did not solve the problem, please contact our designated retailer and A/S designated shop.
- For safety, do not disassemble the product yourself, and keep it in the original condition to avoid further damage.
4
Control panel
Possible Causes
Power plug disconnected
/power outlet with no electricity
Power switch is off
Filter life span is over
Air intake/Exhaust port is blocked or dirty
Filter is installed in the wrong direction
Filter is extremly dirty
Make sure all dirt and dusts have been removed
After making sure that all dirt and dusts have been removed, check the surface for damage.
If there are substances in the air intake and exhaust port, wipe it clean.
While the plasma function is on, some noise is normal
Solutions
Try using different power outlet and check the power
plug is properly connected
Press "ON/OFF" button
Replace filter
Clean the Air intake/Exhaust port
Re-install the filter in the correct direction
Replace filter
<
1
2
3
4
5
•
•
•
•
•
•
•
•