Cleaning The Well, Basket Support And Accessories; Fault - Ndustrio 091FR1ED Manual De Uso E Instalación

CLEANING THE WELL, BASKET SUPPORT AND ACCESSORIES

To carry out this operation, proceed as follows.
1 - Switch the appliance off and leave it to cool
(see page 12).
2 - Turn off the
breaker to disconnect it
from the
mains.
3 - Drain and filter the oil
(see page 13) .
4 - Remove and clean the
baskets and the basket
support structure (A).
5 - Use the lever (B) to
swing the heating ele-
ments (C) into the verti-
cal position.
6 - Apply a food-grade de-
tergent to the inside of the well.
7 - Rinse the well with drinking water and
drain.
8 - Apply a specific product or a water and
vinegar solution to the well to remove the
detergent residues.
9 - Rinse, empty and dry the well.
IT
TROUBLESHOOTING
The appliance has been tested before being put
GB
into service.
The information provided below is intended to as-
DE
sist in the identification and correction of any anom-
alies and malfunctions which might occur during
use.
FR

Fault

ES
The heating elements do not
come on
The appliance does not heat up to
the set temperature
The control panel does not come
on
English
circuit-
electrical
A
Electrical connection not made
Safety thermostat tripped
Contactor not receiving electrical
Electronic circuit board not receiv-
10 - After use, clean the accessories with a suitable
grease-remover product. If possible, wash in
the dishwasher.
C
Important
When using water for routine cleaning,
check that there are no traces of water left
in the well, on the accessories and in the
drain line before refilling with oil.
FAULT
The user can solve some of these problems him-
self, but for others specific technical knowledge or
skill is required, and so they must only be carried
out by qualified staff with recognised experience ac-
quired in the specific sector of operation.
Cause
correctly
power or faulty
ing electrical power
- 16 -
B
IDM-39614401200.tif
Remedy
Check the connection of the elec-
trical wires
Carry out the appliance reset (see
page 13)
Check the condition of the ther-
mostat and activate any ignition
enabling device
Check or replace the contactor
coil
Check or swap the phase wire
connections
6