General Specifications - Memscap SP 844 Instrucciones De Operación

General Specifications

Parameter
Pressure Range (FSO)
Over Pressure (Max)
Sensitivity
Electrical excitation
Input Resistance (Min)
Output Resistance (Max)
Non-linearity (Max)
Zero Balance (Max)
Thermal Sensitivity Shift (Max)
Thermal Zero Shift (Max)
Operating temperature
Storage temperature
Isolation Resistance (Min)
Leak Current (Max)
Weight
Connector
Accessories
No degradation or loss of performance due to proximity of RF communication
equipment or electromagnetic disturbances is expected during normal operation.
The Transducer does not utilize RF energy for operation.
Detail information regarding accessories is found on page 15
81972 rev.10
16
SP 844
Physiological Pressure Transducer
RoHS compliant according to 2011/65/EU (RoHS2 directive)
Range
-30 to 300 mmHg
10 000 mmHg
5 µV/V/mmHg, ±3%
4-8 VDC or -AC up to 5 KHz
200 Ω
3000 Ω
0,5% of FSO
±50 mmHg
0,15%/°C
0,25 mmHg/ °C
+15 to 40°C
-25 to +70°C
1GΩ
1,5 µA @250V, 50Hz
28 gram (without cable)
Equipment specified
Dome Model no.: 844-28, 844-
31, 844-33 or 844-34
Line-set Model no. 844-26
PLEASE NOTE: your transdu-
cer has been wired and calibra-
ted for use with a specific type of
monitor. If you wish to change
connector in order to adapt this
transducer to another type of
monitor, please be aware of pos-
sible differences between moni-
tors, regarding required sensiti-
vity, impedance, AC or DC exci-
tation.
Warning: A change of cables
or connectors may affect the
EMC for the transducer.
Langmyra 11, N-3185 Skoppum
MEMSCAP AS
Norway
Tel.: +47 33 08 40 00
e-mail: [email protected]
www.memscap.com
A3 - HHas 03/2018