Defrost; Maintenance; Cleaning; Changing Over The Door Hinges - JP Selecta EMPLOW-S Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

INSTRUCTION MANUAL
J
.P. SELECTA s.a.u.
CODE 80115
REV E
FEB 2017
In case of a small amount of product to be frozen:
- wait approx. 6 h.
- Place wrapped produce in the deep bottom drawers.
In case of the maximum amount of product to be frozen (see type plate):
- wait about 24 h.
- Remove the deep bottom drawers and place produce directly on the
bottom shelves.
- SuperFrost is automatically deactivated after about 65 h.
- TheSuperFrost button (4) extinguishes once freezing is completed.
- Place product in the drawers and push the latter back in again.
- The appliance continues to operate in the energy-saving, normal mode.

8.8 Defrost

The No-Frost system is responsible for the automatic defrosting of the
appliance.
Moisture from the freezing process adheres to the evaporator. It will be de-
frosted and periodically evaporated automatically.
Note:
- Do not defrost manually.

9 Maintenance

9.1 Cleaning

-
BEFORE START TO CLEAN UNPLUG THE EQUIPMENT FROM THE SOCKED
- Clean the cabinet with warm water mixed with a small quantity of the soap.
- DO NOT USE CLEANING STEAM DEVICES. IT IS A DANGER FOR THE PEOPLE
AND FOR THE EQUIPMENT.
- Try the water used do not reach the air inled grid or the electric elements.
- Dry the equipment with a soft dry cotton cloth.
- Clean once a year the duster acumulated on the compresor and the rear
part grid. This acumulation increases the energy consumtion.
- During the cleanig consumption, pay atention on avoiding that pipes or
other parts may get broken.
- After fi nishig the cleaning, connect the freezer again, activate the function
superfrost and put inside the low freezed products as soon as the tempe-
rature reaches the set temperature again.
If the appliance is to be left out of operation any length time, empty it, discon-
nect from the mains and clean it. If necessary, left the door opened in order
to avoid unpleasant smells.

9.2 Changing over the Door Hinges

To change the opening direction of the door, do as follows: disconnect the
equipment from the mains and ensure that the following tools are to hand:
- Torx 25
- Torx 15
- Open-ended spanner size 6
- Screwdriver
- Open-ended spanner included in supply package
ATENCIÓN
Risk of injury if the door tips!
Take good hold of the door and set down the door carefully.
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: [email protected] - website: www.jpselecta.es
(It can be modifi ed without notice)
Tel 34 937 700 877 Fax 34 937 702 362
Pag.: 19
Tabla de contenido
loading

Este manual también es adecuado para:

2101278

Tabla de contenido