Tabla de contenido
Idiomas disponibles
Idiomas disponibles
If activated, the Smartech© anti-snoring system will start the motors and move the user to a position that will reduce
or completely eliminate the snoring, which is often due to the sleeping position of the neck.
It must be taken into consideration that at least 20 seconds of snoring activity is required for the signal to be
acknowledged; at that point, the motorized slats will incline by approximately 10% versus its starting position. The
system will go back to its initial position after 1 minute (throughout this time interval, the discrimination system of
the signal remains in stand-by).
The Smartech© anti-snoring system may not be accurate and will activate involuntarily if there is continuous noise
in the room.
An improper microphone position (with the ideal position at the center of the head of the bed, 40 cm above the height
of the pillow) may affect the optimal performance of the Smartech© anti-snoring system.
Furthermore, this version is also equipped with a massage system (in fixed mode) which, if operational, will activate
the massage function in the front and/or rear position of the motoized slatted bedframe.
The "SmarTech© Mattress" version collects vital parameters (breathing and heartbeat), during the rest stage, which
are determined through a set of sensors connected to a central control card, which allows for the following functions:
1) Detection of the average heart and breathing frequencies;
2) Detection of the humidity within the room and the ambient temperature;
3) Detection of the mattress temperature;
4) Detection of the luminosity in the room, ambient sound pressure and atmospheric pressure;
5) Detection of the frequency of movements of a person laying in the bed.
Chromotherapy system based on the lighting of RgB LED lights, which are located under the bed frame;
6) The lighting can can be set through the cell phone "APP".
The "Smartech© Mattress" continuously records data without any need for the user to wear sensors. The sensors
are inside the mattress, allowing the processing of data and other relevant access to be recorded in Real Time, either
in proximity of the device or remotely.The smartphone is only used to control the beginning and the end of the data
recording session. It is not required to place the phone in close proximity to the bed.
3.1.2 OPeraTION OF THe DaTa aCQUIsITION sYsTem
From the moment the system is connected to the power supply (green LED lights under the Smartech© Station
Tabla de contenido
