Safety Advice; Declaration Of Conformity - m&h Inprocess RWP38.41 Instrucciones De Operación

Radio-wave Touch Probe RWP38.41

Safety Advice !

1. Manual or automatic positioning of the probe should be protected,
so that the machine axis stops feeding if the probe is triggered during its move
to the position where actual measuring should begin.
2. Feedhold or spindle-stop resulting from a trigger or ready signal from a probe
should only happen if the probe is actually in the spindle.
This security logic will protect the machine against a possible spindle or feeding
stop under normal milling operation if a signal from a probe reaches the control
under one of the conditions below:
•
Customer is changing the batteries and checks the function of the
probe by manually switching the probe on.
•
A new machine is installed with radio-wave transmission with the same
frequency as a probe already fitted to an existing machine.

Declaration of Conformity

We declare under our sole responsibility that the product „ Radio-Wave Touch Probe RWP38.41"
to which this declaration relates is in conformity with following standards:
R&TTE-Directive 99/5/EG
EN 300 220-1 V2.3.1 (2010-08)
EN 300 220-2 V2.3.2 (2010-08)
EMC- Directive 2004/108/EG
EN 301 489-1 V1.8.1 (2008-04)
EN 301 489-3 V1.4.1 (2002-08)
EN 6000-4-2 (2009-12)
FCC / RSS - Declaration
In Progress: Application done - Confirmation coming soon!
Electromagnetic compatibility and Radio spectrum Matters (ERM);
Short Range Devices (SRD); Radio equipment to be used in the 25 MHz to 1 000 MHz
frequency range with power levels ranging up to 500 mW;
Part 1: Technical characteristics and test methods
Electromagnetic compatibility and Radio spectrum Matters (ERM);
Short Range Devices (SRD); Radio equipment to be used in the 25 MHz to 1 000 MHz
frequency range with power levels ranging up to 500 mW;
Part 2: Harmonized EN covering essential requirements
under article 3.2 of the R&TTE Directive
Electromagnetic compatibility and Radio spectrum Matters (ERM);
ElectroMagnetic Compatibility (EMC) standard for radio equipment and services;
Part 1: Common technical requirements
Electromagnetic compatibility and Radio spectrum Matters (ERM);
ElectroMagnetic Compatibility (EMC) standard for radio equipment and services;
Part 3: Specific conditions for Short-Range Devices (SRD)
operating on frequencies between 9 kHz and 40 GHz
Electromagnetic compatibility (EMC) - Part 4-2: Testing and
Measurement - Examination of the discharge immunity static electricity
12