Assembling And Mounting The Fan Blades - Famination Distinction A1 Serie Manual Del Propietário

Assembling and Mounting the Fan Blades

Assembling and Mounting the Fan Blades
1. Lay flat side of blade holder on a flat surface with
the inside of the blade holder facing up. This is the
side with the threaded posts and pitched foot.
Position the blade over the blade holder with the
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade holder.
Place blade holder cover on top of the blade,
positioning the holes over the threaded posts. With a
Philips screwdriver, thread both screws into the posts
but do not fully tighten. Prior to final tightening,
position the centerline of the blade holder with the
center of the end of the blade. Tighten both screws to
secure the blade. (Figure 1)
NOTE: You will find the fan blade set packed in its own
carton and the blade holders and hardware bag in the
fan box.
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
2. Remove and discard the motor stops from the
motor assembly by removing the screws. (Figure 2)
3. Attach assembled blade holders to the motor
hub using the provided screws with lock washers.
Make sure the screws securing the blade holders
to the motor hub are tight and that the blade
holders are properly seated. (Figure 3)
NOTE: Periodically check Blade Holder hardware and re-
secure if necessary. (see Maintenance below)
WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.
CAUTION
Blade
Holder
HARDWARE USED:
#8-32
Serrated Head
Screw-Short
#8-32
Serrated Head
Screw-Long
NOTE: Assemble the B2 and B6 blades with short screws.
Assemble the B1, B3, B4, B5, B7 and B8 blades with long
screws.
Motor
Assembly
Screw
(2 per blade
holder)
HARDWARE USED:
1/4 -20
SCREWS
14
Blade Holder Cover
Figure 1
x 20
x 20
Motor Stops
Figure 2
Figure 3
x 10
Blade