Drain Hose - Fisher & Paykel AquaSmart WL37T26D Instructivo De Instalación

nstaHation inst uctions
Drain hose
1 Carefully pull the drain hose out from the
back of the washer by pulling the exposed
part of the hose downwards and outwards,
2 To guide the drain hose over the set tub/sink
or standpipe the hose guide MUST be fitted
to the drain hose,
To prevent siphoning
The drain hose should not extend more than
q" (20 ram) from the end of the guide,
The height of the standpipe or set tub/sink
should be between 33 W'to 78"(850--- 1200 ram),
The drain hose can be trimmed to length,
Place the drain hose in the set tub/sink or
standpipe,
PL/I[hose
through guide
I s,_" ( 20 ram}
maximum
Flex hose
guide apart
Fig.2Iitdng the droin hose guid(*
In multiostorey apartments or any upper floor installation, the washer should be installed on a
draH_ed floor.
Check that the _ub or stan@ipe is free from lint or other obstructions before operating the washer.
In a bdsement ins_alledon do not exceed e stendpipe height of 9d" (2438 ram),
Inlet hoses
1 Install hoses with the straight end (with filters) fitted to the faucets (refer to Fig.3),
2 Install elbow ends onto clothes washer (inlet valves are marked on the back of the washer
H :hot, C=cold) (refer to Fig.4).
f?g.3 f cluce_end of hose £g.4 Wosherend of hose