Makita SA4542C Manual De Instrucciones página 9

For tool with locking screw type wheel guard
1
2
012733
Mount the wheel guard with the protrusions on the wheel
guard band aligned with the notches on the bearing box.
Then rotate the wheel
counterclockwise. Be sure to tighten the screw securely.
To remove wheel guard, follow the installation procedure
in reverse.
For tool with clamp lever type wheel guard
009430
Pull the lever in the direction of the arrow after loosening
the screw. Mount the wheel guard with the protrusions
on the wheel guard band aligned with the notches on the
bearing box. Then rotate the wheel guard around 180 ﾟ.
1
009431
Tighten the wheel guard with fastening the screw after
pulling lever in the direction of the arrow. The setting
angle of the wheel guard can be adjusted with the lever.
To remove wheel guard, follow the installation procedure
in reverse.
Installing or removing depressed center
wheel or multi-disc (optional accessory)
WARNING:
When using a depressed center wheel or
•
multi-disc, the wheel guard must be fitted on the
tool so that the closed side of the guard always
points toward the operator.
1. Wheel guard
2. Bearing box
3. Screw
3
guard around
1. Wheel guard
1
2. Bearing box
3. Screw
4. Lever
2
3
4
2
1. Screw
2. Lever
012988
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
onto the spindle.
ﾟ
180
1
2
012727
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
To remove the wheel, follow the installation procedure in
reverse.
Installing or removing abrasive disc
(optional accessory)
NOTE:
Use sander accessories specified in this manual.
•
These must be purchased separately.
012742
Mount the rubber pad onto the spindle. Fit the disc on
the rubber pad and screw the sanding lock nut onto the
spindle. To tighten the sanding lock nut, press the shaft
lock firmly so that the spindle cannot revolve, then use
the lock nut wrench and securely tighten clockwise.
To remove the disc, follow the installation procedure in
reverse.
9
1. Lock nut
1
2. Depressed
2
center wheel
3
3. Inner flange
1. Lock nut wrench
2. Shaft lock
1. Sanding lock nut
1
2. Abrasive disc
2
3. Rubber pad
3