Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ÉPIX Bar Tour QRG
Filter
Installation
Power
Linking
Scrambled
Pulse-Width
Modulation
Mounting
The ÉPIX Bar Tour includes a black stealth filter already installed. Follow the
procedure below to install the white frost filter.
1.
Locate the end cap of the product that does not have the connecting hardware.
2.
Remove the 4 screws from the end cap of the product.
3.
Remove filter.
4.
Re-install end cap.
Be sure to install the frost filter with the shiny side facing toward the LEDs.
This product is powered by an ÉPIX Drive 900. Refer to the ÉPIX Drive 900 user
manual for detailed instructions on how to connect this product to power.
You can link up to 6 ÉPIX Bar Tour products on each ÉPIX Drive 900 product.
Never exceed this number.
To eliminate unnecessary wear and improve its lifespan, during periods of
non-use completely disconnect the ÉPIX Drive 900 from power via breaker or
by unplugging it.
This product features Scrambled-PWM (S-PWM) technology, which de-
synchronizes the pulse widths of each color of the multi-color LEDs. This ensures
that there is always some LED output, reducing flicker, and maintaining the same
grayscale performance.
Before mounting this product, read the
point per product. Make sure the mounting clamps are capable of supporting the
weight of the product. For our CHAUVET Professional line of mounting clamps,
go to http://trusst.com/products/.
Safety Loop Eye Bolts
End Cap
Safety
Notes. Use at least one mounting
Overhead Mounting
4
Mounting Clamp
EN
Tabla de contenido
