Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
Power
This product is powered by an ÉPIX Drive 2000 IP or ÉPIX Drive 900. Refer to the ÉPIX Drive 2000 IP/900 User Manuals
for detailed instructions on how to connect this product to power.
Power Linking
You can link up to 20 EPIX Strip IP 50 products to each port of an ÉPIX Drive 2000 IP. Never exceed this number.
•
Use ONLY IP65 4-pin XLR cables with the EPIX Strip IP 50. For our CHAUVET Professional line
of IP65 4-pin XLR cables, go to https://www.chauvetprofessional.com/accessories.
•
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect
the ÉPIX Drive 2000 IP from power via breaker or by unplugging it.
Scrambled Pulse-Width Modulation
This product features Scrambled-PWM (S-PWM) technology, which de-synchronizes the pulse widths of each color of the
multi-color LEDs. This ensures that there is always some LED output, reducing flicker, and maintaining the same
grayscale performance.
Filter Installation
The EPIX Strip IP 50 includes a Square Milky Filter already installed. Follow the procedure below to install the included
Black Stealth Filter or Round Milky Filter.
1.
Locate the end cap of the product that does not have the interlocking hardware.
2.
Push in on the end-cap latch.
3.
Slide the installed filter out and replace it with the desired filter.
4.
Release the end-cap latch.
3
QUICK REFERENCE GUIDE
End-Cap Latch
Interlocking Hardware
EPIX Strip IP 50 QRG Rev. 2
Tabla de contenido
