How To Operate; Helpful Tips - Nostalgia Products ISM1000 Manual Del Usuario

HOW TO OPERATE

• Fill a standard ice cube tray with water and place in
freezer until frozen. Remove ice from tray(s).
• Place the ELECTRIC SNOW CONE MAKER on a stable, waterproof
surface near an electrical outlet before starting.
• Always make sure that the cord is away from a water source.
• With Shaver Bowl placed on top of Base, place frozen ice cubes in Shaver Bowl.
• BE CAREFUL when placing ice cubes in Shaver Bowl. The blade in the Shaver Bowl is
very sharp.
• Place a cone under the Shaver Bowl to catch the shaved ice.
• Place the Motor Cabinet on top of the Shaver Bowl and hold in place. When filled with
ice, the Motor Cabinet will rest a few inches above the bottom of the Shaver Bowl.
• Plug in the unit. The ELECTRIC SNOW CONE MAKER operates at one speed. While holding the
Motor Cabinet steady with one hand, press the Power Button. It will start with a gentle press.
• Press continuously until majority of ice is shaved, or until the Motor Cabinet sits flush on
the bottom of the Ice Bowl. To stop shaving ice, release pressure on the Power Button.
• Some ice may remain in the Shaver Bowl. Discard this ice before adding a new ice cube.
• Repeat the process until you have the desired amount of shaved ice.
• After each 1 minute of continuous use, wait 10 minutes
before using again to allow motor to cool.
• Unplug unit from outlet when finished.

HELPFUL TIPS

USING TRADITIONAL ICE CUBES
• Place 10 medium-sized ice cubes in an even layer in Shaver
Bowl to yield approximately 2 cups of shaved ice.
• Do not overfill Shaver Bowl with ice.
6