Team kalorik TKG SIS 1001 Manual De Instrucciones página 16

Fax +32 2 359 95 50
STEAMING IN A VERTICAL POSITION
Position the temperature dial on its maximum level for vertical steam ironing. The steam rate
can be adjusted according to your needs.
You have to hang the cloth you want to smooth out avoiding the creases and place the iron in
a vertical position at a few centimetres from the piece of cloth. Then move the iron and press
the burst of steam button at the same time.
DRY IRONING
•
Plug in the appliance and switch it on (power switch in position "I").
•
Use the temperature dial to set the temperature needed.
•
When the indicator lamp of the iron goes out for the second time, you can start ironing.
•
For ironing without steam, leave the steam control knob in OFF position and do not press
the steam button.
WHEN FINISHED IRONING
•
We recommend cleaning the iron after use as follows: fill the water tank, put the
temperature dial on position "LINEN" and the steam regulator on MAX and let the iron
heat for 10 minutes. When the temperature has been reached, take the iron from the
base, hold it vertically and keep the steam button pressed for 30 seconds, then wait 30
seconds and repeat this cycle twice.
•
Switch off the appliance (power switch in position "0"), unplug the appliance and let it
cool down.
•
Empty the water tank.
•
We recommend placing the iron on its base when you store it. The therefore foreseen
place is non-slip and will not damage the soleplate of the iron.
ANTI-CALC DEVICE
•
Your appliance is equipped with an anti-calc device located inside the water tank. As a
result, you can use tap water as it will be filtered by the device.
•
Never use the appliance without water tank!
CLEANING
•
The plastic parts of the appliance can be cleaned with a damp cloth.
•
To clean the soleplate of the iron, you will find specific products in the shops. Please also
read the instructions of use. Never use abrasive products to clean it.
•
Never immerse the appliance in water or any other liquid.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
16
Assembly page 16/64
TKG SIS 1001 - 130827