3M PELTOR WS LiteCom Plus Manual Del Usuario página 35

TECHNICAL DATA
POWER
Powered by a rechargeable Li-ion battery pack (ACK081).
3.7 V, 1800 mAh
OPERATING TIME
Expected operating time (according to
standardized measurement) in room temperature
with ACK081
EXTERNAL INPUT
3M™ PELTOR™ Type J111-A
RADIO
Frequency range
Operation mode
Antenna
Channels
Channel raster
Channel spacing
Modulation
Receiver sensitivity
Output power Bluetooth
Output power
EXTERNAL INTERFACE PIN OUT
®
Pin 1
Pin 2
Pin 3
Pin 4
WS LiteCom Plus: Approximately 18 hours
TM
LiteCom Plus: Approximately 20 hours.
4-pole connector for external equipment
FRS: 462.56250- 467.71250 MHz
*Bluetooth 2402-2480 MHz
®:
Half-duplex
¼ wave, integrated whip antenna
Fixed to the headset
Omni directional
Gain: 0 dBi
22 channels
12.5 kHz
12.5 kHz
Analog: Max narrow 2.5 kHz (FM)
Typical -120 dBm
2.5 mW ERP
High power: 150 mW ERP.
Low power: 25 mW ERP
EXTERNAL PTT
Activated when shorted to Pin 2 (ground)
GROUND
INPUT
The input signal is mixed with the WS™ WS LiteCom Plus Headset
audio output level (speaker output).
120.5 mV = Input signal level for which the mean plus one standard
deviation equals 82 dB(A) in cup.
BOOM MICROPHONE OUTPUT
Applied signal at the boom microphone input comes out on pin 4
2.25 mV Microphone input = 30 mV output
* Only WS (Bluetooth
TM ®
Bluetooth
PCB antenna
Gain: 0 dBi
) models
:
®