Replacing Injectors; Adjusting The Minimum Setting - Franke FHM 604 4G Instrucciones Para El Uso E Instalacion

b)they are both easily accessible and positioned so that no electrical part can be accessed
when inserting or unplugging the same plug
c)the plug can be inserted without difficulty
d)the plugged in and fitted oven is not resting on the plug
e)do not connect the terminals of two appliances to a single plug
f)if the power cable needs to be replaced use a 3 x 1.5 mm2
cable type H05VV-F
g it is vitally important to observe the polarities of the free
)
terminals
(Brown=Live – Blue=Neutral – YellowGreen=Earth)
N.B: ensure the characteristics of your domestic
electrical power supply (voltage, maximum output and
current), are compatible with those of your FRANKE hob.

Replacing injectors

Warning. All appliances are factory-set for G20 natural gas (methane).
In the event a different type of gas is to be used, change the injectors as follows:
1. remove the panstand grids, burner caps and flame-spreader crowns;
2. unscrew and remove the injectors and replace them with those supplied suitable for
3. replace the flame-spreader crowns, burner caps and panstand grids;
4. these particular burners do not require any air adjustment.
Warning
When converting the appliance to a different type of gas, remember to apply the self-
adhesive label (supplied with accessories) indicating the type of gas used in the relevant
section on the dataplate. For operation with L.P .G. (G30 or G31) fully screw down the
minimum flame setting screw. This is a cat. II 2H3+ appliance.

Adjusting the minimum setting

- Remove the control knobs (which have a push-on
- Ignite the burners and adjust the minimum setting
the domestic gas supply, ensuring that the injector marking corresponds to that given in
the table (page 15);
design for ease of removal).
by turning the adjustment screw clockwise to
reduce the flame and anti-clockwise to increase it
(fig. 3). The screwdriver for carrying out this
adjustment is supplied with the other accessories.
Highest
minimum setting
Lowest
minimum
setting
Fig. 3
17