Bosch GBH 18V-36 C Professional Manual Original página 11

Power tool status Meaning/cause
indicator (20)
Motor is jammed, battery too weak
General error
Flashing red Rapid shut-off is triggered
– In combination with the
rapid shut-off
indicator (17)
Flashing blue Power tool is connected to a mobile device or
settings are being transferred
Smartphone status Meaning/cause
indicator (21)
Green Additional information available (e.g. com-
mercial information)
Yellow Important information available (e.g. temper-
ature warning)
Red Operation-critical information available
(e.g. engine stop due to an error in the mi-
crontroller unit)
Selecting the working mode
– Press the (19) button for selecting the working mode re-
peatedly until the working mode you require lights up.
Working mode (18) indic- Functions
ator
In Auto working mode, the power tool reaches maximum performance.
lights up
– "Hammer drilling" operating mode: Rapid increase in speed for controlled drilling up to
– "Chiselling" operating mode: Adaptive Speed Control
– Rapid shut-off (KickBack control)
Soft operating mode is used to machine delicate materials.
lights up
– "Hammer drilling" operating mode: EPC active, slow increase in speed for soft starts up to
– "Chiselling" operating mode: Adaptive Speed Control with an even more sensitive setup
– Rapid shut-off (KickBack control) with an even more sensitive setup
In Favorite working mode, the power tool can be individually configured via a smartphone
lights up
app.
– "Hammer drilling" operating mode can be configured in several steps:
– "Chiselling" operating mode: Adaptive Speed Control can be switched on and off
– Sensitivity of rapid shut-off (KickBack control) until switch-off can be configured
Bosch Power Tools
Note: In Favorite working mode, the functions are con-
figured via the smartphone app, while the functions are pre-
set in Auto and Soft working modes.
100 % of the maximum speed
80 % of the maximum speed for hammer drilling in sensitive surfaces
Power via speed
Electronic Precision Control (EPC) via start-up speed
Solution
Charge the battery or use the recommended
battery type
– Switch the power tool off and on again, or
remove the battery and reinsert it
If the error persists:
– Send the power tool to the after-sales ser-
vice
Turn the power tool off and on again
–
Solution
If you are interested in this, read the message
on the smartphone
Read the message on the smartphone
Read the message on the smartphone imme-
diately
1 609 92A 4Z7 | (28.10.2020)
English | 11