Safety Chain Brake - sunjoe SWJ700E Manual Del Operador

• Ensure safe carrying of the chain saw. Whenever the
machine is to be handled or transported, you must:
– switch off the motor, wait for the chain to stop, and
enable the chain brake;
– mount the guide bar cover;
– hold the machine using the hand grips and
position the bar in the opposite direction to that used
during operation.
When using a vehicle to transport the machine, fasten
it firmly and position it so that it is not a danger to
any passengers.
• Before felling or delimbing for the first time, make sure:
– you have been specifically trained to use this type
of equipment;
– you have carefully read the safety regulations and
user instructions contained in this manual;
– you practice first on logs on the ground or attached to
trestles/saw horses, in order to get familiar with the
machine and the proper cutting techniques.

Safety Chain Brake

In the event that kickback occurs, use your left hand to apply
the chain brake by moving the safety chain brake lever to
position 0 (Fig. A). This will immediately stop the chain.
The operation of the chain brake must be checked prior to
each use.
m
WARNING! To reset the chain brake, disconnect the tool
from the mains power and snap the chain brake backwards
(towards the operator) into position 1 (Fig. A). Recheck the
chain tension before restarting.
Fig. A
1
Safety chain
0
brake lever
Protection from environmental influences
1. Wear suitable work clothes. Wear safety goggles.
2. Protect your power tool from moisture and rain.
Moisture and rain can cause dangerous electrical and
motor damage.
3. Do not use the power tool near vapours and
flammable liquids.
4. Use the power tool only in dry conditions and at an
ambient temperature of 50-104°F (10-40°C).
5. Store your power tool only in dry locations with an
ambient temperature of 50-104°F (10-40°C). Protect the
power tool from humidity and direct sunlight.
5