BH FITNESS H9120 Manual De Instrucciones página 6

1. Press any key to switch the monitor
on.
2. Press the MODE key to start the
small DIST (DISTANCE)
flashing.
3. Press the SET keys to select the
distance.
4. Begin the exercise and the distance
value will begin the countdown, when
it reaches zero it will beep, advising
you that the selected distance has
been covered, the distance value will
then start counting upward.
C. CALORIE FUNCTION.-
This function counts up or down in
steps of 10 calorie(s), up to a
maximum of 9990 calories.
Pressing the MODE key for more
than two seconds will reset all of the
values.
1. Press any key to switch the monitor
on.
2. Press the MODE key to start the
small CAL
flashing.
3. Press the SET keys to select the
calories.
4. Begin the exercise and the calorie
value will begin the countdown, when
it reaches zero it will beep, advising
you that the selected calorie value has
been reached , the calorie value will
then start counting upward.
D.- TELEMETRIC PULSE RATE.-
To measure your pulse rate during
exercise you will need to wear the
chest band (OPTIONAL). Fig.3.
window
(CALORIE) window
TROUBLESHOOTING GUIDE.-
Problem: The display comes on but
only the Time function works.
Solution:
a.- Make sure that the connection
cable is connected.
Problem: The display does not come
on or the displayed segments are very
weak.
Solution:
a.- Check that the batteries are fitted
correctly.
b.- Check the battery charge.
c.- If they are run down change them
immediately.
Problem: Display segments of a
function read-out are not visible or
error messages
function appear.
Solution:
a.- Remove the batteries for 15
seconds and then refit them correctly.
b.- Check the battery charge If they
are run down change the batteries
c.- If the above steps do not help then
replace the electronic monitor.
Avoid leaving the electronic monitor in
direct sunlight as this might damage
the liquid crystal display. Similarly, do
not expose it to water or knocks.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
THE MANUFACTURER KEEPS THE
RIGHT TO MODIFY THE PRODUCT
SPECIFICATIONS
PREVIOUS ADVISE.
6
for a particular
WITH NO