Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
NOTE: To avoid the oscillation of the operator during operating phase, it is recommended to adjust
the nut (1) being careful not to block the rotation of the operator on the fitting.
Fig. 12
POSITIONING OF THE FRONT FIXATION
Once the operator has been mounted on the back fixation close the leaf and do as follows:
1) Release the operator.
2) M
ount the operator on the front fixation.
ATTENTION: When mounting the operator on the front fixation lubricate the pivot with grease.
3) Tighten the screw (A) at max 8,5 Nm.
WARNING: For the proper operation of the actuator and of the limit switches (if any) it is important
to put the motor and the front and back fixings in a perfectly horizontal position, using the spirit
level as shown in Fig.14.
Fig. 14
Spirit
level
WELDING OF THE FRONT FIXATION TO THE GATE
Depending on the type of the gate (wood, iron, aluminium) the front fixation can be welded or
screwed.
38mm
6 2 m m
Srewed front fixation
67411010
®
Nut (1)
(1)
=
110 mm
62mm
=
Welded front fixation
Fig. 15
Rev. 09 - 07/2013
SURF
English
English
Fig. 13
(A)
Front
fixation
110 mm
Fig. 16
19
