Introduction; Features; Front Panel - Phonic CA35 Manual Del Usuario

INTRODUCTION

Congratulations on your purchase of a Phonic CA mixer/amplifi er.
These mixer/amplifi ers can mix up to four or six individual signals
with power output rated at 35, 60, 120 or 240 Watts. The CA series
is ideal for small sound reinforcement systems. An additional zone
2 output with 8 ohm or 600 ohm output connections is included
for versatile side fi ll or multi-zone operation. Users are able to set
priority VOX operation with a variable threshold control. A +24V
phantom power supply is included for condenser microphones.
A number of stereo RCA connectors with summed inputs are
onboard for inclusion of music sources. A transformer-isolated
output connection is included with 8 ohms, 70V and 100V line
output application possible. Variable bass and treble controls are
available on the master output.

FEATURES

Three-channel mixer/amplifi er (CA35)
Four-channel mixer/amplifi er (CA60)
Six-channel mixer/amplifi er (CA120 and CA240)
Three output operating modes: 8 ohms, 70V and 100V
Output power of 35W, 60W, 120W or 2x120W (for the 35, 60,
120 and 240 respectively)
Wide frequency response of 70 Hz to 18 kHz ±2dB
Low distortion and ultra-low noise level
Master bass and treble controls
User-assignable zone 2 output
Balanced channel 1 input
Telephone paging output
User-controlled VOX priority
+24V phantom power for mics
Chime and Announce tones built into CA120 and CA240
Two, three or four RCA input connectors (model dependent)
Input channel 2 offers XLR and ¼" TRS jacks on CA120 and
CA240
CA35 / CA60 / CA120(B) / CA240(B)
Versatile heat and voltage protection for the amplifi er
24V battery connection for rechargeable batteries (CA120B
and CA240B)
Compact design and low weight

FRONT PANEL

1. Input Level Controls
Controls in the input level control for the corresponding
channels.
2. Master Level Control
This controls the fi nal output level before sending to the output
connectors.
3. Master Output Indicators
The green LED above the Master level control will light up
when the output signal exceeds -40dB indicating that a signal is
present. The red LED indicator will light up when the output signal
reaches high peaks with the potential of causing distortion.
4. Bass Control
Turning to the right will increase the response of low-frequency
signals (100 Hz) in your main audio signal. Turning to the left will
decrease the response of low-frequency signals.
5. Treble Control
Turning to the right will increase the response of high-frequency
signals (10 kHz) in your main audio signal. Turning to the left will
decrease the response of high-frequency signals.
6. Chime & Alert Tones
These two buttons will send an alert or an announce tone through
to the speakers. The alert button can also be used to activate
a siren, the length of which will be 2 minutes and 30 seconds.
Pushing the Alert button a second time will disengage the siren.
The ''announce' button will active a 3 second 'do mi so do' tone
to indicate an announcement. Activating either of these tones will
cut out all music and other input sources.
7. Power Button and Indicator
This button turns the CA mixer/amplifi er on. When the unit is
turned on, the LED indicator will illuminate to indicate as such.
Be sure that the mixer amplifi er is turned on after all other input
sources.
1 6 3 4 2 5 7
1