Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. handling / Operation
3.1 Tools
Use only clean tools!
3.1.1 Changing/Fitting the tool
Hold spindle by wrench flats with open end wrench and
release/tighten down collet chuck with open end wrench.
Perform a trial run a minimum over a period of 30 seconds
without load.
3.2 Working instructions
On failure of the compressed air release the valve
lever! To achieve an optimum result, move grin-
ding tool uniformly back and forth with light pres-
sure. Excessive pressure lessens the working capability
of the machine, as well as the life of the grinding tool.
4. Service / Maintenance
4.1 Preventive maintenance
Without a tool clamped in check no-load
speed periodically and after each mainte-
nance. Even if the machine still operates
perfectly, the motor should be removed, cleaned and the
four slides checked for wear by a specialist after approx.
300 to 400 operating hours. The lubricant in the gear
head (Isoflex NBU 15) should be replaced at the same
time (do not wash out!).
4.1.1 Replacement of the exhaust air hose
Detach the exhaust air hose from the swivel ring, and re-
place it.
4.1.2 Replacement of the supply hose
Remove the exhaust air hose (see 4.1.1).
Detach the hose clip, and pull the supply hose off the
connection nipple.
19
Tabla de contenido
