Security Warnings - HACE MJS-501 Manual De Instrucciones

Security warnings

Please be aware of the following points to prevent danger of high voltage.
1. Never disassemble the base unit without consulting qualified personnel.
2. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
3. Do not add detergents or chemical solutions to the water.
4. Unplug the appliance during filling, cleaning and maintenance.
5. Keep detergents and chemical solutions away children.
6. Do not change the attachment without definite permit from the manufacturer.
7. If you notice any abnormal smell during normal operations, please switch off the unit and discon-
nect power supply and contact the manufacturer.
8. Never touch the water in the water basin or the components in the water when the unit is in opera-
tion.
9. Never switch the unit on when there is no water in the water basin.
10. Never scrape transducer cpl at will.
11. Never clean transducer cpl with detergents or chemical solutions.
12. Never let water splash into the inner base unit.
13. Care should be taken when using the appliance due to emission of hot water vapor.
14. Before cleaning and maintenance, the appliance must be disconnected from the main supply.
15. This appliance is not intended for use by persons (including children) with reduced physical, senso-
ry or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
18. Children should be supervised to ensure that they do not play with the appliance.
19. Indoor use only.
20. Prior to cleaning or other maintenance, the appliance must be disconnected form the main supply.
How to clean the filter system:
1. Clean the ceramic balls after being used for 1000L of water.
2. Remove the filter system from the tank cover.
3. Put the filter system in the white vinegar for about 10 minutes.
4. After 10 minutes; shake the filter system several times then clean it with clear water.
5. Alternatively, take out the ceramic balls from the filter system and wash them with clean
water then let them dry in direct sunlight for several hours before putting them back in the filter
cartridge.
5. Let the filter system dry and pack it into a polybag. Keep it in a cool and shady place.
How to clean the transducer:
1. Put 5-10 drops of cleaning liquid on the surface of the transducer, wait for 2-5 minutes;
2. Brush away the scale on the surface.
3. Rinse the transducer with clean water.
How to clean the basin unit:
1. Clean the water basin with a soft cloth and use cleaning liquid if there is scale in it.
2. Rinse the water basin with clean water.
5