Singer SNG 9.26 Instrucciones página 6

Start ironing the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to heat up than to cool down) and
eliminates the risk of scorching the fabric.
STEAM IRONING
Filling the reservoir
- Check that the plug is disconnected from the socket.
- Move the steam selector (9) to "0" [Fig. 1].
- Open the lid (7).
- Raise the tip of the iron to help the water enter the opening without overflowing.
- Slowly pour the water into the reservoir using the special measure and taking care not
to go over the maximum level (about 350ml) indicated by "MAX" on the reservoir
[Fig. 2].
- Close the lid (7).
Selecting the temperature.
- Put the iron in a vertical position.
- Put the plug in the socket.
- Adjust the thermostat knob (2) according to the international symbol on the LCD display
screen [Fig. 1]. The STANDBY symbol flicker indicates that the iron is heating up. Wait
until the plate "STANDBY" symbol no flicker before ironing.
Warning: STANDBY symbol comes on at intervals, indicating that the selected tem-
perature is maintained. If you lower the thermostat temperature after ironing at a high
temperature, do not start ironing until STANDBY symbol glints again.
Selecting the steam.
The quantity of steam is regulated by the steam selector (9).
- Press the steam selector to a position between grade 3 and grade 4 depending on the
quantity of steam required and the temperature selected [Fig. 1].
Warning: the iron gives off steam continuously only if you hold the iron horizontally. You
can stop the continuous steam by placing the iron in a vertical position or by moving the
steam selector to "0". As indicated on the thermostat knob (2) and in the initial table, you
can only use steam at the highest temperatures. If the selected temperature is too low,
water may drip onto the plate. At garde 1 and 2, there is no steam come out.At garde 3
and 4, only when the temperature come to the setting point, there is steam come out.
Selecting Shot-steam and steam when ironing vertically.
Press the shot-steam button (5) to generate a powerful burst of steam that can penetrate
the fabrics and smooth the most difficult and tough creases. Wait for a few seconds
before pressing again [Fig. 4].
By pressing the shot-steam button at intervals you can also iron vertically (curtains, hung
garments, etc.) [Fig. 5].
Warning: the shot-steam function can only be used at high temperatures. Stop the emis-
sion when "STANDBY" symbol flicker comes on, than start ironing again only after the
light has gone off.
DRY IRONING
To iron without steam, follow the instructions in section "steam ironing", leaving the steam
selector (9) on position "0".
Spray Function
Make sure that there is water in the reservoir. Press the spray button (11) slowly (for a
dense spray) or quickly (for a vaporized spray).
4
6_Instruction Manual.indd 4
GARMENT
LABEL
FABRIC
TYPE
synthetic
silk - wool
Cotton - linen
Fabric not to be ironed
THERMOSTAT
REGULATION
low temperature
medium temperature
high temperature
08.02.2012 09:02