Tabla de contenido
Idiomas disponibles
Idiomas disponibles
START UP
ES
a. Park the appliance on a flat surface.
b. Insert the mains plug into the socket.
c. Supply water to the appliance
PT
* For the connection values, see the nameplate.
WARNING: Impurities in the water can damage the high
pressure pump and accessories.
EN
d. Drain the water from the open tanks.
* This high pressure cleaner is suitable to work with the suction hose
with a backflow valve to suck up surface water, eg. Eg from water butts
FR
or ponds.
and. Fill the suction hose with water.
F. Screw the suction hose into the water connection of the appliance and
insert it into the water source (eg rainwater drum).
g. Purge the device as follows before operation:
▶ Turn on the switch "0/1"
▶ Unlock the trigger lever.
▶ Push the trigger lever, the device will turn on.
▶ Let the device run (max. 2 minutes) until the water comes out without
bubbles from the trigger.
▶ Release the trigger lever.
▶ Lock the trigger lever.
USE OF THE MACHINE
WARNING: Running dry for more than 2 minutes will
damage the high pressure pump. If the appliance does
not build up pressure within 2 minutes, switch it off and
proceed according to the instructions in the Chapter
"Troubleshooting".
HIGH PRESSURE OPERATION
WARNING: Keep a distance of at least 30 cm when using the
jet to clean painted surfaces to avoid damage.
WARNING: Make sure the on / off switch is in the "OFF / O"
position and insert the plug into a properly installed socket.
ATTENTION
Connect the product to the power and water supply as described below
in the following list :.
▶Turn on the water supply
Instruction manual
▶Hold the spray gun with both hands.
▶Point the nozzle of the chosen accessory away from you towards the
▶Unlock the trigger and press it until a steady amount of water flows
▶Release the trigger.
▶Turn on the "0/1" switch.
▶Hold the spray gun with both hands. Direct the stream of water at
▶Release the trigger lever; the device will turn off again and stop the
WARNING: Beware of kickback when pressing the trigger!
DETERGENT OPERATION
Detergent can only be added when the device is operating in low
pressure mode.
▶Remove the cap from the clean detergent bottle.
▶Carefully remove the onboard detergent container from its storage
▶Fill the tank with detergent specifically designed for use with
▶Push the detergent bottle with the opening pointing down into the
RECOMMENDED CLEANING METHOD
▶Spray the detergent sparingly on the dry surface and allow it to
surface to be cleaned.
through the nozzle, to allow any air trapped in the hose to escape.
the object to be cleaned and press the trigger.
water jet. High pressure remains in the system.
WARNING: When using detergents, the material safety
data sheet issued by the detergent manufacturer must be
observed, especially the instructions regarding personal
protective equipment.
position.
pressure washers.
connection for the clean hose detergent
08680
REF.
Tabla de contenido
