Tabla de contenido
Installing an optical drive-small form factor desktop model
Read the following information first before attempting to install your new
optical drive in the system.
1. Remove the cover and all cables. Refer to your system user's guide for
details on how to remove cover and cables.
2. Remove the riser card housing and place the housing as shown in the
illustration below.
3. Remove the optical drive from its package.
4. Remove the existing optical drive (some models) from the slimline bay. If
your system does not have an optical drive, you must remove the blank
panel or EMC shield from the front of the slimline bay.
5. Install the optical drive into the slimline bay.
6. Plug the Combo cable into the back of the optical drive. Plug in all three
connectors to the system board. Refer to your system user's guide for more
details.
Chapter 2. Installing the drive in slimline IBM systems
2-3
Tabla de contenido
