Cleaning And Maintenance - Princess 332928 Manual De Instrucciones

• Before use, hold the mains plug and
unwind a sufficient length of the mains
cable from the back of the appliance.
• After use, press the mains cable rewind
button (2) to rewind the mains cable back
into the appliance. Manually guide the
mains cable to make sure that it does not
swing back. Make sure that the mains plug
is correctly located.
Adjusting the length of the tube
(fig. A)
• Keep the locking knob (20) pressed and
slide the extension tube (8) to the required
position.
• Release the locking knob (20).
Adjusting the suction nozzle (fig. A)
The floor surface selector can be set to adjust
the suction nozzle to the required floor surface.
The floor surface selector can be operated by
hand or foot.
• For vacuuming on laminates, tiles, etc.,
press the corresponding part (A) of the
floor surface selector (13).
• For vacuuming on carpets, press the
corresponding part (B) of the floor surface
selector (13).
Switching on and off (fig. A)
The on/off button can be operated by hand
or foot.
• To switch on the appliance, press the
on/off button (1).
• To switch off the appliance, press the
on/off button (1) again.
Adjusting the suction force (fig. A)
The speed control button can be used to
adjust the suction force.
• Set the speed control button (3) to the
required position:
- For vacuuming on hard surfaces
(e.g. floors), set a high suction force.
- For vacuuming on soft surfaces
(e.g. upholstery), set a low suction force.
Adjusting the airflow (fig. A)
The airflow can be adjusted using the airflow
control switch.
• To adjust the airflow, set the airflow
control switch (11) to the required
position.

Cleaning and maintenance

Before you proceed, we need you to pay
attention to the following notes:
- Before cleaning or maintenance, remove
the mains plug from the wall socket and
wait until the appliance has cooled down.
- Do not immerse the appliance in water or
any other liquids for cleaning.
Before you proceed, we would like you to
focus your attention on the following notes:
- Do not use aggressive or abrasive cleaning
agents to clean the appliance.
- Do not use sharp objects to clean the
appliance.
• Regularly check the appliance for possible
damage.
• Regularly clean the ventilation slots using
a soft brush.
• Store the appliance in a dry place, out of
the reach of children.
Replacing the dustbag (fig. B - D)
The dustbag (25) must be replaced when the
bag-full indicator (4) comes on. Replacement
dustbags are available from our service
station. If you have questions regarding the
dustbag, contact the service station.
• To remove the full dustbag (25), refer to
the section "Mounting and removing the
dustbag".
• To mount the empty dustbag (25), refer to
the section "Mounting and removing the
dustbag".
Cleaning and replacing the motor
filter (fig. B - E)
Before you proceed, we would like you to
focus your attention on the following notes:
- Do not wash or rinse the motor filter.
The motor filter (29) reduces the amount of
dust entering the motor unit to a minimum.
The motor filter must be cleaned regularly.
The motor filter must be replaced after several
months or whenever worn or damaged.
13