Allett CLASSIC 14L Manual Del Usuario página 15

Petrol
Petrol deteriorates over time. Engine starting
may be difficult if you use petrol kept for more
than 30 days. Always run the fuel tank dry when
storing over 30 days.
1. Remove the petrol filler cap
leaded petrol to the tank
halfway up the fuel strainer.
2. Replace the petrol filler cap 7.
3. Wipe up any spilt petrol from the engine be-
fore starting the mower.
Engine Oil
B
The mower is not supplied with oil in the engine,
however it is possible that there is a small quan-
tity in the engine. It is essential to fill with oil be-
fore starting the engine to avoid damage to
your engine. It is important to use the recom-
mended oil to avoid damage to your engine.
1. With the mower standing on level ground,
unscrew and remove the oil filler dipstick 17.
2. Wipe the oil filler dip stick 17 clean; insert the
oil filler dip stick 17, then remove it again. Do
not screw it in. Check the oil level.
3. Add a good-quality SAE 10W-30 API SF in small
quantities at a time, allowing it to settle. Re-
peatedly add oil and check the level until it
reaches the max. position dip stick 17. The
engine may require up to 0.4 litres of oil.
4. Refit the oil fill dipstick 17.
Grassbox
C
Spring the grassbox cradle 20 into
holes 18.
Attach/remove the grassbox 10 as shown.
Height of cut adjustment
C
Your machine has six settings which give the fol-
lowing approximate height of cut:
1 = 9 mm 2 = 13 mm
4 = 25 mm 5 = 32 mm
Position "S" should only be used with the Scari-
fier Cartridge accessory (purchased separately).
To adjust the height of cut:
Tilt the mower to take the weight off the front
roller 21.
Push the height of cut knob 19 in and turn to the
desired position.
For the first cutting of the season, a high cutting
adjustment should be selected.
F016J10012B Page 15
D
Starting and Stopping
Starting from Cold
1. Move the throttle lever
7, slowly add un-
8, fill to approx.
2. Move the engine cut-off switch 6 to "1"
3. Move the choke lever 11 to
4. Pull the recoil cord handle 13. Allow the recoil
5. Gradually turn the choke lever
Starting from Hot
Follow "Starting from Cold" using steps 1 & 4
only.
If the engine does not start or will not continue
to run, follow the "Starting from Cold" proce-
dure with choke 11 lever between the
and
D
1. Move the throttle lever
2. Move the engine cut-off switch
D
1. Start engine.
2. Push the red safety latch 2 forward and grad-
3. Gradually squeeze the drive control lever
pivot
4. Release the safety button
5. Adjust the speed as required by moving the
6. To stop, release both control levers
3 = 18 mm
S = Scarifier
3
Using Your mower
D E
1 to position
handle to return slowly after each pull.
position.
Stopping
1 to position
Engaging cylinder cutter and rear roller
ually squeeze the cutter control lever
wards the top handle 5.
towards the top handle 5.
throttle lever 1 between
.
.
11 to .
.
6 to "0".
3 to-
4
2.
and .
4 and 3.