CS-20NM1HPP
CS-25NM1HPP
C
ONTENTS
Before installation .............................................................................. 1
Drain piping work............................................................................... 3
Wiring example.................................................................................. 4
Test operation .................................................................................... 5
Special features ................................................................................. 6
Maintenance ...................................................................................... 6
Wiring diagram .................................................................................. 7
READ THESE INSTRUCTIONS CAREFULLY BEFORE
INSTALLATION. KEEP THIS MANUAL IN A HANDY
PLACE FOR FUTURE REFERENCE.
IMPROPER
INSTALLATION
EQUIPMENT OR ACCESSORIES COULD RESULT IN
ELECTRIC SHOCK, SHORT-CIRCUIT, LEAKS, FIRE OR
OTHER DAMAGE TO THE EQUIPMENT. BE SURE ONLY
TO USE ACCESSORIES MADE BY PANASONIC WHICH
ARE SPECIFICALLY DESIGNED FOR USE WITH THE
EQUIPMENT AND HAVE THEM INSTALLED BY A
PROFESSIONAL.
IF UNSURE OF INSTALLATION PROCEDURES OR USE,
ALWAYS CONTACT YOUR PANASONIC DEALER FOR
ADVICE AND INFORMATION.
B
EFORE INSTALLATION
I
Leave the unit inside its packaging until you reach the
installation site. Where unpacking is unavoidable, use a sling of
soft material or protective plates together with a rope when
lifting, this to avoid damage or scratches to the unit.
Refer to the installation manual of the outdoor unit for items not
I
described in this manual.
Precautions
I
Do not install or operate the unit in rooms mentioned below:
•
Places with mineral oil, or filled with oil vapour or spray like in
kitchens. (Plastic parts may deteriorate.)
•
Where corrosive gas like sulphurous gas exists. (Copper
tubing and brazed spots may corrode.)
•
Where volatile flammable gas like thinner or gasoline is used.
•
Where machines generating electromagnetic waves exist.
(Control system may malfunction.)
•
Where the air contains high levels of salt such as air near the
ocean and where voltage fluctuates a lot (e.g. in factories).
Also in vehicles or vessels.
Do not install accessories on the casing directly. Drilling holes in
I
the casing may damage electrical wires and consequently cause
fire.
CS-20•25NM1HPP
Urban Multi air conditioner
4PW12341-1A
Urban Multi air conditioner
Page
OR
ATTACHMENT
OF
Accessories
Check if the following accessories are included with your unit.
Installation and
operation manual
Optional accessories
I
There are two types of remote controllers: wired and wireless.
Select a remote controller according to customers request and
install in an appropriate place.
Refer to catalogues and technical literature for selecting a
suitable remote controller.
Suction air filter.
I
Wiring adaptor for electrical heater.
I
For the following items, take special care during
construction and check after installation is finished
Tick
when
checked
Is the indoor unit fixed firmly?
I
The unit may drop, vibrate or make noise.
I
Is the gas leak test finished?
It may result in insufficient cooling.
I
Is the unit fully insulated?
Condensate water may drip.
Does drainage flow smoothly?
I
Condensate water may drip.
I
Does the power supply voltage correspond to that shown on the
name plate?
The unit may malfunction or components may burn out.
Are wiring and piping correct?
I
The unit may malfunction or components may burn out.
Is the unit safely grounded?
I
Dangerous at electric leakage.
I
Is the wiring size according to specifications?
The unit may malfunction or components may burn out.
I
Is nothing blocking the air outlet or inlet of either the indoor or
outdoor units?
It may result in insufficient cooling.
Are refrigerant piping length and additional refrigerant charge
I
noted down?
The refrigerant charge in the system might not be clear.
Installation and
operation manual
Caution for servicing
Fuse
sticker
Installation and operation manual
1