Sharp SJ-TA35CHDIE-EU Manual De Uso página 12

CHAPTER -3: USING YOUR FRIDGE FREEZER
Door Open Alarm Function
If either the fridge or freezer door is left open for more than 2 minutes, the appliance will beep.
Temperature Settings
Freezer Temperature Settings
• Press icon (#9 on control panel diagram), until the
'Freezer temperature setting' is selected (#1).
• Once Freezer temperature setting is selected, the
temperature will flash.
• Users can then use the up or down arrow (
set the temperature (-16, -18, -20, -22, -24°C and Super
Freeze Mode).
• If Super Freeze mode or Eco mode is activated, the
temperature will not change until the mode is cancelled.
Cooler Temperature Settings
• Press icon (#9 on control panel diagram), until the 'Fridge temperature setting' is selected (#1).
• Once Fridge temperature setting is selected, the temperature will flash.
• Users can then use the up or down arrow (
Mode).
• If Super Freeze mode or Eco mode is activated, the temperature will not change until the mode is cancelled.
Warnings About Temperature Adjustments
• Your temperature adjustments will not be deleted when an energy breakdown occurs.
• It is not recommended that you operate your fridge in environments colder than 10°C.
• Temperature adjustments should be made according to the frequency of door openings, the quantity of food
kept inside the fridge and ambient temperature of the placement of your fridge.
• Your fridge should be operated up to 24 hours according to the ambient temperature without interruption after
being plugged in, this is so it is completely cooled. Do not open the doors of your fridge and do not place food
inside it during this period.
• A 5 minute delay function is applied to prevent damage to the compressor of your fridge, when you take the
plug out and then plug it back in again after an energy breakdown has occurred. Your fridge will start to operate
normally after 5 minutes.
• Your fridge is designed to operate in the ambient temperature intervals stated in the standards, according to
the climate class stated in the information label. We do not recommend operating your fridge out of the stated
temperatures value limits in terms of cooling effectiveness.
• This appliance is designed for use at an ambient temperature within the 10°C - 43°C range.
Climate class and meaning:
T (tropical): This refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to 43 °C.
ST (subtropical): This refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to
38 °C.
N (temperate): This refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to
32 °C.
SN (extended temperate): This refrigerating appliance is intended to be used at ambient temperatures ranging from
10 °C to 32 °C.
Temperature indicator
In order to help you better set your refrigerator, we have equipped it with a temperature indicator located in
the coldest area.
To better store the food in your refrigerator, especially in the coldest area, make sure the message "OK"
appears on the temperature indicator. If "OK" does not appear, this means that the temperature setting has
not been done properly.
Since "OK" appears in black, it will be difficult to see this indication if the temperature indicator is badly lit. To
be able to see this indication properly, there should be enough light.
Each time the temperature setting device is changed, wait for the stabilisation of the temperature inside the appliance
before proceeding, if necessary, with a new temperature setting. Please change the position of the temperature setting
device progressively and wait at least 12 hours before starting a new check and potential change.
NOTE: Following repeated openings (or prolonged opening) of the door or after putting fresh food into the appliance, it
is normal for the indication "OK" not to appear in the temperature setting indicator. If there is an abnormal ice crystals
build-up (bottom wall of the appliance) on the refrigerator compartment evaporator (overloaded appliance, high room
temperature, frequent door openings), set the temperature setting device to a lower position until compressor off
periods are obtained again.
/ ) to
/ ) to set the temperature (8, 6, 5, 4, 2°C and Super Cool
EN -11-
OK