Howard LWL-TP-22-120 Instrucciones De Instalación

LED W L
ork ight
LWL-TP-22-120 (
WiTh
SAFETY PRECAUTIONS
• Do not open the work light body; no user serviceable parts inside.
• Do not look directly at lighted fixture. Do not remain in bright light if skin feels warm
as you are too close to the fixture.
• Keep fixture away from children.
• Never use around heavy volatile fluids such as gasoline.
• Never operate the fixture with missing glass safety shield.
• This fixture is not intended for use nor safe to use in potentially dangerous locations
such as places with explosive or flammable atmospheres.
• Do not handle this fixture when standing on wet or damp surfaces or in water. To
reduce the risk of electrical shock, this light should always be plugged into properly
grounded 3-wire outlet. If used while exposed to wet or damp surfaces a ground
fault outlet (GFCI) should always be used. Do not remove the ground wire or
grounded plug from the fixture. Always use a U.L. listed 3 wire grounded cord with
electrical capacity to properly handle this light and other tools you might be using.
Never use light around swimming pool, hot tubs or saunas.
• Use only with an extension cord for outdoor use, cord type:
SW,SW-A,SOW,SOW-A,STW,STW-A,STOW,STOW-A,SJW-A,SJOW,SJOW-
A,SJTW,SJTW-A, or SJTOW,SJTOW-A
• When an extension cord is used with this luminaire, the maximimum cord length
shall not exceed 50 feet (15.2 m) from where the cord exits the luminaire to the
receptacle.
assEMBLY instructions
1. Carefully remove the fixture and all the parts from the box.
Set out the tripod legs and loosen the black adjustment knob.
Slide center pole through adjustment sleeve and into bottom
pole receiver. Tighten receiver bolt so pole receiver is secure
to pole. Tighten adjustment knob so legs stay fixed in place.
If the floor is not flat, the tripod can be adjusted by loosening
the nut on the extension leg.
portion of fixture. (See Figure 1)
2. Using carriage bolts, hex nuts, and flat washers, fix the
U-shaped bracket to the H base.
3. Mount the fixture to the top of the tripod then tighten the
center knob. Be sure not to over-tighten the center knob.
(See Figure 2)
4. Lamp height can be adjusted by loosening the compression
nut, sliding pole to desired height and retightening the nut.
(See Figure 3)
1
Need help? Call 1-800.956.3456 to speak with our installation and product experts.
i i
nstaLLation nstructions
T )
riPod
Now you are ready to install top
2
(p) 601.422.0033 | (f) 601.422.1652 | Toll-Free: 800.956.3456
PARTS LIST
• (1) TP Tripod Assembly
• (1) LWL-22-120 Work Light
• (1) Work Light Stand
• (1) Parts Bag
• (2) 1.25"L ¼-20 Carriage Bolts
• (2) ¼" Flat Washers
• (2) ¼-20 Hex Nuts
• (1) ¼-20 Knob Screw
REqUIREd TOOLS
• Adjustable Wrench
3
580 Eastview Drive | Laurel, MS 39443
www.Howard-Lighting.com
Revised 3/26/2016