Practical Advice - Bimar HI-PET HC01P Folleto De Instrucciones

Fax +32 030 9904733

The set comes with:
- 1 clipper
- no.1 comb : for cutting hair to 3mm (6) + no.2 comb :
for cutting hair to 6mm (7) + no.3 comb : for cutting hair
to 9mm (8) + no.4 comb : for cutting hair to12mm (9)
- 1 tube of lubricating oil
- 1 metal brush (12)
- 1 metal comb (14)
- 1 small brush for cleaning (16)
- 1 file (13)
- 1 nail clipper (11)
- 1 case (7)
Using the combs
Attach the desired comb onto the blades (first make sure you've
removed the 10" blade cover) with the teeth upwards,
postioning it so that the 3 hooks lock into place (you will hear a
click for the correct attachment), see figures to the side for the
proper attachment.
USE
• Plug into the power point.
• Press the switch while in pos. On.
•
The appliance has a Turbo function, which allows you to increase the speed.
• The device can operate continuously for up to 20 minutes, after which requires a break of
at least 20 minutes before using it again. Failure to do this may affect the performance of
the appliance.
• If the blades get blocked, disconnect the appliance from the mains.
• Once finished: turn the switch to pos. Off and remove the plug from the power outlet.
If the device is not in use for long periods of time, remove the plug from the plug
point.

Practical advice

•
It is advisable to start with the largest comb, going to the smaller one if you want a
shorter cut.
•
To get an even cut, the device should not move too quickly through the hair, as it has
its optimal operating speed.
•
Once you attach the desired comb, cut the hair by properly supporting the teeth of the
comb. It is advisable to proceed with small cutting sections to prevent the blades from
clogging. If necessary, simply remove the comb. Then perform the same movement
starting from a lowest point to obtain an even cut.
•
The guide comb: Attach a guide comb appropriate for the desired coat length, as
described.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
12 40
/
Assembly page 12/40