Installation
1
Installing the connector
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Wrap thread sealant tape (not included) around
the stub out pipe threads (1) extending from the
wall in a counterclockwise direction, as shown.
□
Place the ange (B) onto the connector (C) and
wrench-tighten the connector (C) onto the stub
out pipes (1) extending from the wall (do not
over tighten).
B
C
2
□
A
1
4
Installing the faucet assembly
Insert the washers (D) into the faucet body (A),
and then wrench-tighten the faucet body (A) to
the connectors (C).
C
D