KENMORE ELITE 580.77107710 Manual De Uso página 11

Cut the non-adhesive foam strip to the proper length
10
and insert it between the upper window sash and
the lower window sash.
Attach the window locking bracket with a type C
11
screw.
Before installing the front grille, fold out the vent
12
control lever located to the left of the control panel
as shown.
Cut the adhesive-backed heatproof foam to match
13
the size of the curtain panels. Remove the backing
from the heatproof foam and attach it to the curtain
panels.
NOTE: The heatproof foam improves the cooling
capability of the air conditioner.
INSTALLATION INSTRUCTIONS
Foam Strip
(Not adhesive
backed)
Window Locking Bracket
Heatproof foam
Connect the wire harness from the front grille
14
assembly to the air conditioner.
Attach the front grille assembly to the cabinet by
15
inserting the grille tabs into the slots on the front
of the cabinet. Push the grille in until it snaps into
place.
NOTE: Carefully guide the vent control lever through
the grille as you push the grille in.
Open the air inlet grille and secure the front grille
16
assembly with 1 type A screw through the bottom of
the front grille. (There are 2 type A screws packed
in a small bag. Use one and store one as a spare.)
The window installation of the room air conditioner
is now complete. See the Electrical Data section for
information on attaching the power cord to an electrical
outlet.
11