Bestway 58516 Manual Del Usaurio página 4

Assembly
(You will need a screwdriver.)
1. Carefully remove all components from the package and check to ensure nothing is
damaged. If equipment is damaged, immediately notify the retailer from where the
equipment was purchased.
2. The sand filter should be placed on solid, level ground, preferably a concrete slab.
Position the sand filter so the Ports and Control Valve are accessible for operation,
servicing and winterizing.
3. The sand filter must be vertically fixed on ground or a certain pedestal made of wood or
concrete before use to prevent the sand filter from accidentally falling. Fully assembled
sand filter will exceed 18kg. The mounting holes should be 8mm in diameter and spaced
285mm apart. Use two bolts and nuts with a maximum of 8mm in diameter to fasten the
sand filter to the pedestal.
Load pool-grade filter sand
NOTE:
Use only special pool-grade filter sand, free of all limestone or clay: #20 Silica sand 0.45-0.85mm, approximately one 8.5kg
bag should suffice. If you do not use the recommended size filter sand, filtering performance will be reduced and the sand filter may
damaged, thereby voiding warranty.
NOTE:
To avoid damaging the Skimmer when adding sand, pour some water into the Bottom Tank to submerse the Skimmer on the
Collector Hub.
NOTE: Sand
Flowclear™ Polysphere not included
/
NOTE:
Use 28 g (0.06 lbs) Flowclear™ Polysphere to replace 1 kg (2.20 lbs) sand.
Connect to the pool
For 38mm(1.5in)
connection
Flowclear™ Polysphere
/
C
C
4
.
.
C
C
Ø8mm
285mm
MAX
MIN