Turnt Abl E Inst All Ation; Count Ertop Inst All Ation - Nevir NVR-6229 MMDG Manual De Instrucciones

Ocultar thumbs Ver también para NVR-6229 MMDG:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Turnt abl e Inst all ation

Hub (underside)
Glass tray
Turntable shaft
Turntable ring assembly
Count ertop
Remove all packing material and accessories.
Examine the oven for any damage such as
dents or broken door. Do not install if oven is
damaged.
Inst all ation
1.
Select a level surface that provide
enough open space for the intake
and/or outlet vents.
30cm
0cm
20cm
20cm
min85cm
(1) The minimum installation
height is 85cm.
(2) The rear surface of
appliance shall be placed
against a wall.
a. Never place the glass tray upside down. The glass
tray should never be restricted.
b. Both glass tray and turntable ring assembly must
always be used during cooking.
c. All food and containers of food are always placed
on the glass tray for cooking.
d. If glass tray or turntable ring assembly cracks or
breaks, contact your nearest authorized service
center.
Inst all ation
Cabin et: Remove any protective film found
on the microwave oven cabinet surface.
Do not remov e th e light brown Mic a cov
er th at is att ach ed to
avity t o prot ect th e magn etron .
(3) Blocking the intake and/or outlet openings
can damage the oven.
(4) Place the oven as far away from
radios and TV as possible.
Operation of microwave oven may
cause interference to your radio or TV
reception.
2. Plug your oven into a standard household
outlet. Be sure the voltage and the
frequency is the same as the voltage
and the frequency on the rating label.
WARNING: Do not install oven over a
range cooktop or other heat-producing
appliance. If installed near or over a heat
source, the oven could be damaged and
the warranty would be void.
The acc essibl e surf
ace may be hot during
op eration .
EN- 11
th e ov en c
Tabla de contenido
loading

Tabla de contenido