Astralpool NanoFiber Manual De Instalación Y Mantenimiento página 3

IMPORTANT: Do not use an iron and hemp pipe for the selector valve connection, it is essential to use plastic
accessories and TEFLON tape. Pipe terminals are available threaded fixing in 1 ½ " and 2".
Always leave enough space round the filter in order to perform the necessary examinations and maintenance
during the filter's life.
ASSEMBLY:
Follow these indications for a correct assembly of the filter:
1.- Place the filter on a horizontal and clean surface.
2.- Place the filter in its final position. There are three holes at the base of the filter to secure it in place.
The fastenings are not supplied.
3.- Fit the 2" multiport valve (code 07444) inside
the filter, whilst ensuring that the seals between
the valve and the filter are in the correct position.
4.- Glue the sleeve (code 65289) to the bottom
2 connection that is supplied with the nanofiber
filter.
5.- Perform the three connections of the selector
valve: pump piping to the valve, valve to the waste
drain and valve to the pool return. Each of these
three outlets is clearly identified on the valve.
6.- Set the manometer T, the joint, the manometer and
the air drainage (see exploded view). It is not necessary
to use teflon tape, as the watertightness is guaranteed in
this case by the joint. Do not tighten the manometer T
with a tool, as manually will be sufficient.
- Gluing sleeve 65289 -
- Assembly of the manometer -
3