Mode Selection
• To switch to the Color Wheel: hold the A button for two seconds and the light will return
to the last color displayed while in the Color Wheel mode. Run your finger around the
color wheel to select a new color.
• To switch to the Preset Light Changing Modes: hold the A button for two seconds, and
the light will return to the last preset mode displayed while in the Light Changing Modes.
Press the I and J button to switch between the different preset modes.
Changing the Brightness and Speed
In all modes, you can use the E and F keys to change the brightness of the light. In all
modes, you can use the G and H keys to change the speed of the light transitions. There are
10 levels for each.
Synchronizing the Remote to the Control Unit
If the remote control stops working properly, please install fresh batteries. If problems
persist, the remote may need to be re-synced to the control module.
Follow the instructions below to re-sync the remote control.
1. Unplug the transformer.
2. Hold the E button down (The red indicator lamp on the remote will be lit).
3. While still holding the E button down, plug in the transformer. The Colorfalls
will start blinking.
• If the Colorfalls blinks three times and stops, the remote and control unit are synchronized.
• If the Colorfalls blinks six or more times, it is clearing all codes. Repeat steps 1-3.
Maintenance
Atlantic's Color Changing Colorfalls has a removable back plate for easy cleaning of the
interior of the spillway. To clean the interior of the spillway, simply remove the screws on
the back plate and remove the baffle (Figure 4). Remove any large obstructions that may
be present and wipe down the interior with a non-abrasive cloth. Once finished, install the
baffle and re-attach the back plate, making sure that the gasket is in place to ensure a
water-tight seal.
Caution: Be extremely cautious when tightening the screws. It is strongly recommended
that you tighten the screws with a hand held screwdriver. Over tightening the screws could
crack the back plate or strip the screw holes. The screws need only be snug for the gasket
to make a seal.
For winterizing, loosen the screws on the back plate to allow excess water to drain. Once
the water is removed from the interior of the spillway, retighten the screws.
LED Light Strip
Figure 4
6
Screws
Back Plate
Colorfalls Body
Baffle
Inlet Plugs