Atlantic SS12 Manual Del Producto página 2

Introduction
Thank you for choosing Atlantic's Color Changing Colorfalls. The Colorfalls are designed for
use in Pond-free and fountain applications. The Color Changing Colorfalls feature a larger
opening which produces a thicker water sheer and less clogging from debris in the water, a
remote controlled Color Changing LED light bar, and a removable back plate that provides
access to the interior of the spillway for easy maintenance and winterizing.
Prior to Operation and Installation
Caution:
•
DO NOT operate this product under any conditions other than those for which it is
specified. Failure to observe these precautions can lead to electrical shock, product
failure, or other problems.
• Follow all aspects of electrical codes when installing the Color Changing Colorfalls.
• To reduce the risk of electrical shock, connect only to a 110 volt receptacle protected by
a ground fault circuit interrupter (GFCI).
• The input power to the Color Changing Control Module is 12 volt AC. The Control Module
can be connected to a larger outdoor lighting transformer; however this must be done
between the Control Module and the transformer. Removing the Control Module or
tampering with the cord between the Control Module and the Colorfalls will damage the
light bar and void warranty.
• The Control Module is weather resistant with an IP54 rating. Do not submerse the Control
Module or expose it to heavy rainfall. It must be mounted off the ground close to the
power source. Failure to do so will void the warranty.
• Colorfalls are designed for use in Pond-free and fountain applications. Colorfalls are not
intended for use in water gardens or any pond with plant or aquatic life.
The ColorFalls must be accessible for service and maintenance. Installing the ColorFalls
so that the entire body is removable is highly recommended. Do not glue the cap stones
above the ColorFalls or permanently mortar the ColorFalls in place.
The Colorfalls can support 40 lbs. per linear foot (e.g. a 24" Colorfalls can support 80 lbs.). If
the weight on the weir exceeds that amount, you will need to provide a lintel support for the
added weight. This support should still make contact with the weir to prevent it from shifting.
See the chart below for the recommended placement of the Colorfalls above the basin or
pool. If the placement of the Colorfalls exceeds the recommended height, water loss will
increase significantly due to splash and wind drift.
Colorfalls
CC06
CC12
CC24
CC36
2
Maximum Falls
Height Above Basin
18"
24"
30"
36"
Flow Rate
600 GPH
1200 GPH
2400 GPH
3600 GPH